08-11-22, 23:29 -
Hi WhiteTigerMort,
Wiring can't be wrong since it's a hat.
The GPIO error message is normal at the first manual start as stopping the autostarted process is ahrd cancel leaving the GPIO's in use (if you ctrl-C and start the box again it won't show up anymore).
The LCD routine is started without error messages.
So for now as I'm as puzzled as well
..did you leave "USE_HD44780_16x2_LCD = False" as is (=False)
Noek
Wiring can't be wrong since it's a hat.
The GPIO error message is normal at the first manual start as stopping the autostarted process is ahrd cancel leaving the GPIO's in use (if you ctrl-C and start the box again it won't show up anymore).
The LCD routine is started without error messages.
So for now as I'm as puzzled as well
..did you leave "USE_HD44780_16x2_LCD = False" as is (=False)
Noek