17-07-22, 21:25 -
Hi tyeutyeu,
Your question for details on controllerCCs.csv and CCmap.csv is already in docs for next release in "more details" tab under Assigning the device knobs, pots, drawbars, pedals to effects/functions - this was indeed quite unclear.
Your dump shows messages for the main controller (keyboard = midichannel 1, coded as 0) and the drumpad (percussion = midichannel 10, coded as 9).
It shows note-on's (message 9 with a velocity) and note-off's (can be message 8 or message 9 with velocity=0: your case).
It also shows control messages on channel 1=0 with a CC number and a value. For pots (continuous controllers) this value varies, for buttons it's fixed.
You can reprogram all this stuff in your arturia.
For the fixed controllers (buttons) this value is coded in the val/value = 3rd column of controllerCCs.csv, for continuous controllers (pots) val should be -1.
I also see system messages (channel F=15 -> 16); these are ignored by samplerbox.
Aftertouch messages on the drumchannel surprise me a bit as they start on full velocity. How is this used by the PC software ??
(note: aftertouch is currently not supported, but support will start at next release and I don't know this behaviour).
Regards, Hans
Your question for details on controllerCCs.csv and CCmap.csv is already in docs for next release in "more details" tab under Assigning the device knobs, pots, drawbars, pedals to effects/functions - this was indeed quite unclear.
Your dump shows messages for the main controller (keyboard = midichannel 1, coded as 0) and the drumpad (percussion = midichannel 10, coded as 9).
It shows note-on's (message 9 with a velocity) and note-off's (can be message 8 or message 9 with velocity=0: your case).
It also shows control messages on channel 1=0 with a CC number and a value. For pots (continuous controllers) this value varies, for buttons it's fixed.
You can reprogram all this stuff in your arturia.
For the fixed controllers (buttons) this value is coded in the val/value = 3rd column of controllerCCs.csv, for continuous controllers (pots) val should be -1.
I also see system messages (channel F=15 -> 16); these are ignored by samplerbox.
Aftertouch messages on the drumchannel surprise me a bit as they start on full velocity. How is this used by the PC software ??
(note: aftertouch is currently not supported, but support will start at next release and I don't know this behaviour).
Regards, Hans